Apollo 70LF-100 Series Bronze Ball Valve, Potable Water Service, Two Piece, Inline, Lever, 4" NPT Female
Free Shipping Included! Apollo 70LF-100 Series Bronze Ball Valve, Potable Water Service, Two Piece, Inline, Lever, 4'' NPT Female by Apollo Valve at In The National Interest. MPN: 70LF10A01. Hurry! Limited time offer. Offer valid only while supplies last. The Apollo 70LF-100 series two-piece inline ball valve for potable water service is made of bronze and has a lever-handle and female National Pipe
The Apollo 70LF-100 series two-piece inline ball valve for potable water service is made of bronze and has a lever-handle and female National Pipe Taper (NPT) threaded connections on both ends. This valve meets CA AB 1953 and VT S.152 for lead free quality assurance and use with potable water. It is made of bronze for higher strength and corrosion resistance than brass and has a zinc-plated steel lever handle with a vinyl sleeve for manual on/off control. The maximum pressure is 600 pounds per square inch (gauge) (psig) for cold working pressure (CWP) and 150 psig forsteam working pressure (SWP). The valve is inline for connecting two pipes going in the same direction and has NPT threads on both ends for creating tighter seals than straight threads. Reinforced polytetrafluoroethylene (RPTFE) seats and stem packing reduce the risk of valve leakage. This ball valve is standard (or regular) port for reduced valve size and cost and has a working temperature range of -20 to 450 degrees Fahrenheit. This valve is used in plumbing and heating applications. It meets standards MSS SP-110 and ANSI/NSF 61 and is registered under CSA B51 (CRN: OC10908.5C) for quality assurance.
Ball valves use a spherical disc to control the flow between pipes, tubes, or hoses. Flow is allowed when the hole that pierces the ball-shaped disc is in line with the inlet and outlet of the valve. Flow is blocked when the ball is horizontally swiveled 90 degrees, so that the hole of the ball is perpendicular to the opening of the valve. Ball valves can be referred to as full port or reduced port (also known as regular or standard port) depending on the inner diameter of the valve. A ball valve is full port if the hole of the ball is the same size as the inner diameter of the connecting pipeline (resulting in lower friction) and is reduced port if the hole of the valve is one pipe size smaller than the pipe, resulting in less flow through the valve than through the shaft of the pipe. Ball valves may have a handle or lever that aligns with the ball’s position (open or closed) for manual operation. They are primarily used in air, gas, liquid, and steam applications.
Apollo manufactures ball, mixing, and relief valves, actuators, water gauges, marine fittings, heating and plumbing products, and backflow prevention devices. The company, founded in 1928 and headquartered in Matthews, NC, meets International Organization for Standardization ISO/IEC 17025:2005 and makes products that meet ISO and American National Standards Institute (ANSI) standards.
Features & Highlights
- Made of bronze for higher strength and corrosion resistance than brass
- Meets CA AB 1953 and VT S.152 for lead free quality assurance and use with potable water
- Zinc-plated steel lever handle with a vinyl sleeve for manual on/off control
- Pounds per square inch (gauge) (psig) rating of 600 for cold working pressure (CWP) and 150 for steam working pressure
- Female National Pipe Taper (NPT) threads for use with male threaded pipes
|Package Weight:||23.5 pounds|
|Package Size:||9.1 x 6 x 6 inches|